配膠完成後需真空脫泡攪拌5鐘至均勻後自主檢查將膠滴於加熱板(溫度180

配膠完成後需真空脫泡攪拌5鐘至均勻後自主檢查將膠滴於加熱板(溫度180±5℃)上確認膠體是否可固化，於熱板旁加入計時器計時15分鐘內需完成固化，若未固化將報廢此膠材。固化後膠體貼於配膠單上。

結果 (英文) 1:

Gum upon completion required vacuum deaerating independent check after 5 minutes until smooth stir resin droplets on the heating plate (180 ± 5 ℃ temperature), confirm that the gel is curable, joined the timer timer for 15 minutes in hot plate next to demand complete cure, if not cured this plastic material will be scrapped. Cured gel applied to the gums on the list.

結果 (英文) 2:

After the completion of required with plastic vacuum degassing stir 5 minutes to even check the gum drops autonomous heating plate (temperature 180 ± 5 ℃) to confirm whether colloid curable, adding timer 15 minutes to complete curing beside domestic hot plate, If not cured plastic material will be scrapped this. Cured gel affixed with plastic sheet.

結果 (英文) 3:

after the completion with plastic to vacuum deaerate stirring 5 Jong-independent inspection will be evenly after plastic drops in heating Board (temperature 180±5°C) recognized colloid could solidify to the hot plates to the timer timing 15 minutes solidify to complete, if not solidifying the scrapped the plastic materials. After attentive to solidify plastic with plastic single.