我們想要知道客戶是用什麼去量測螺紋深度超過12mm，因為經過我們廠內用

我們想要知道客戶是用什麼去量測螺紋深度超過12mm，因為經過我們廠內用牙規去做檢測，檢測結果如下49支3”有15支是OK的，34支是不OK的，而4” 29支皆是ok的。而造成不良品的原因並非螺紋深度而是牙距(因為就算螺紋深度很深，鎖不進去就不會有影響。)此外，良品我們會退還給你們，而不良品我們會再寄補寄品給你們。

結果 (英文) 1:

We want to know what the customer is measured by the amount of thread depth of more than 12mm,
because through our factory with regulatory teeth to do testing, test results are as follows
49 3 "is OK there are 15, 34 is not OK, and 4 "29's are all ok.
The cause of a defective product but not the teeth from the thread depth
(because even if the thread depth is deep, do not go lock will not be affected.)
In addition, the yield we will be returned to you, we will not yield resent send you a replacement product for you all.

結果 (英文) 2:

We want to know what the customer uses to measure thread depth sits at more than 12mm,
Because after our factory with dental rules to do testing, test results are as follows
Forty-nine 3" 15 are OK, 34 are ok, and 4" 29 are OK.
And the cause of the bad product is not the thread depth but the distance
(Because even if the thread depth is deep, the lock doesn't have an impact.) )
In addition, good products will be returned to you, and the bad products we will send you supplements.

結果 (英文) 3:

We want to know what the customer is using to measure the thread depth over 12mm,
Because we used the tooth gauge in our factory to do the test, the test results are as follows
Of the 49 "3", 15 were OK, 34 were not OK, and 4 "29 were OK.
The cause of the defect is not the thread depth but the pitch
(because even if the thread depth is very deep, it will not affect if the lock is not in.)
In addition, we will return the good products to you, and we will send the defective products to you again.