一，设置F0-09为0或1（切换运行方向）。二，点动运行试试方向是否正

一，设置F0-09为0或1（切换运行方向）。二，点动运行试试方向是否正确，变频器是否有报故障。三，方向正确而且无故障报警，即完成换向设定。如果变频器有报警，还需设置F1-30为0或1（切换编码器信号方向）。

結果 (英文) 1:

1. Set F0-09 to 0 or 1 (switch the running direction). 2. Check whether the direction of jog operation is correct and whether the inverter reports a fault. 3. The direction is correct and there is no fault alarm, that is, the reversing setting is completed. If there is an alarm in the frequency converter, you also need to set F1-30 to 0 or 1 (switch the encoder signal direction).

結果 (英文) 2:

1、 Set F0-09 to 0 or 1 (switch running direction).
2、 Jog and run to see if the direction is correct and if the frequency converter has reported a malfunction.
3、 The direction is correct and there is no fault alarm, that is, the reversing setting is completed.
If the frequency converter has an alarm, it is also necessary to set F1-30 to 0 or 1 (switch encoder signal direction).

結果 (英文) 3:

First, set F0-09 to 0 or 1 (switch the running direction).
Second, try whether the inching operation direction is correct and whether the inverter has reported a fault.
Third, the direction is correct and there is no fault alarm, that is, the commutation setting is completed.
If the frequency converter has an alarm, it is also necessary to set F1-30 to 0 or 1 (switch the encoder signal direction).