10)合模到位，點擊“注膠”按鈕，打開安全閥的氣壓調節閥，給安全閥施加

10)合模到位，點擊“注膠”按鈕，打開安全閥的氣壓調節閥，給安全閥施加合適的氣壓；設定合適的手動轉速，按右按鈕注膠，查看模具注膠道是否堵塞；
11)要卸模具時，先合模到位，把壓模條螺絲擰松，讓壓模條離開模具，再點動開模按鈕就能卸走模具。

結果 (英文) 1:

10) clamp in place, click on the "glue" button to open the pressure regulating valve safety valve, put appropriate pressure on the safety valve setting appropriate speed manually, press the right button to gel, see if the mold injection road congestion;11) to discharge the mold, and clamp in place, loosen screw of compression mould, die out of the mold, and then unloaded the jog mode button to open the mold.

結果 (英文) 3:

10) mold in place, click the "glue" button, open safety valve, pressure regulating valve, the proper air pressure is applied to the safety valve; right hand speed setting, press the right button glue injection, view mould note glue channel is blocked;11) to remove the mold, after clamping in place, to die a screw loose, let die strip out of the mold, then move mold button removed mold.