結論： " 務必確認 Susceptor 表面任絕緣程度低的兩點 也不

結論：
" 務必確認 Susceptor 表面任絕緣程度低的兩點
也不能造成導通。"


4-3. 確認兩裝置皆安裝妥善。(如圖 8)

(兩治具接觸需為 Short 狀態。)
" 4-4. 以檢測出表面絕緣度較差的點為基準，
做表面量測。一定需為 OL (如圖 9)"

結果 (英文) 1:

Conclusion: "Be sure to confirm the Susceptor surface insulation with low two-point Not causing conduction. " 4-3. recognizes that the two devices are installed properly. (See Figure 8) (Two fixtures contact for Short State. )"4-4. the detected surface insulation low point as the benchmark, Surface measurement. Must for the OL (Figure 9) "

結果 (英文) 2:

Conclusion:
"sure Susceptor any surface low insulation levels of two points
can not be caused by conduction. " 4-3 to confirm the two devices are installed properly. (Figure 8) (two fixtures required for the Short contacting state.) "4-4. In poor detection of the surface of the insulating degree as a benchmark for surface measurements. necessarily need to OL (Figure 9). "

結果 (英文) 3:

Conclusion: it is important to make sure that the two points of the low insulation level of Susceptor surface can not be caused by conduction. "


4-3. confirmed two device is installed properly. (Figure 8)

(two fixture contact required for the Short state.
"4-4. to detect the low degree of insulation on the point of reference,
do surface measurement. Must be OL (Figure 9)