在做機械點位校正之前,我們必須進入做齒輪比校正,這是一個特殊功能操作,

在做機械點位校正之前,我們必須進入做齒輪比校正,這是一個特殊功能操作,目的是針對馬達做直接的運動控制,且在HT的各機型上都具備類似的功能,因此在設備系統上沒有對這個功能作完善的防呆保護,故在操作上請操作者須再三確認所輸入的數值是否正確,並確認是以慢速進行,以免發生危險.

結果 (英文) 1:

Before doing the mechanical point correction, we must enter the gear ratio correction. This is a special function operation. The purpose is to perform direct motion control on the motor, and all HT models have similar functions. Therefore, in the equipment The system does not have complete anti-fool protection for this function, so during operation, the operator must repeatedly confirm whether the entered value is correct and confirm that it is performed at a slow speed to avoid danger.

結果 (英文) 2:

Before performing mechanical point calibration, we must proceed to perform gear ratio calibration. This is a special function operation aimed at direct motion control of the motor, and it has similar functions on various models of HT. Therefore, there is no complete foolproof protection for this function in the equipment system. Therefore, during operation, the operator must repeatedly confirm whether the input values are correct and confirm that it is done at a slow speed to avoid dange

結果 (英文) 3:

Before mechanical point correction, we must do gear ratio correction, which is a special function operation, aiming at direct motion control of the motor, and all models of HT have similar functions, so there is no perfect foolproof protection for this function in the equipment system, so the operator should repeatedly confirm whether the input value is correct and make sure that it is carried out at a slow speed to avoid danger.